20 Most Recent
1987 Chevrolet Chevette Questions & Answers
Where can I obtain a
most early chevy's used the HEI ignition set up this included a cap with a coil sitting on top
87 Chevette - washer failure prob
the only thing i can think of is a bad pump. try taking the power wires off of the pump and see if you are geting power with a test light. if you are not it is probally a blown fuse if you are it is most likely a bad pump
Which is the approximate maximum speed of the 1976 chevrolet chevette ?
I've been driving Chevettes since 1980 and I currently own six of them, in 2019 lol! if your engine is in tune and there is no wind, I've had my speedo buried, so approximately 90mph, since the speedo goes to 80mph. it also depends if you have the 4 speed or auto trans, and your rear axle ratio. 1976 Chevette came with a 3.70 to1 or a 4.11 to 1 gear ratio.
2/11/2019 2:56:29 AM •
Chevrolet...
•
Answered
on Feb 11, 2019
I have 2009 Corvette, with battery problems as
it has a draw, and they will be best equipped to find it. There are more modules on that car than the shuttle. it may take them a while, its warranty right?? its just a process of elimination, removing modules/ components from the "LOOP" until the draw goes away. good luck
8/1/2013 7:13:15 PM •
Chevrolet...
•
Answered
on Aug 01, 2013
How to hook up vacuum
When attaching vacuum lines, you need to remember only one thing. Mark each hose when you remove it from the original carb (quadrajet?) Hoses that attach to the baseplate are at full vacuum and should be returned to a similar location or to the manifold, using a "tree". Hoses that are connected to the body of the original carb only see vacuum when the throttle is opened. Those can be attached to the fitting on the right side of the front metering block. Most Holley carbs have no provision for the valve located at the front of early Q jets (bowl purge) nor do they have any electrical connections except for the choke mechanism.
The most important vaccuum line is the one for your power brakes. Make sure that one is firmly connected either to the rear of the carb baseplate or the manifold. All other lines are nowhere as critical as that one is..
11/5/2012 10:40:31 PM •
Chevrolet...
•
Answered
on Nov 05, 2012
Not finding what you are looking for?