the service manual covers all that, buy it or rent it?
V8 Engine. 1996 Infinity Q45
scans said it bad, if not do not listen to dweebs saying it is bad blind,
not told why you want to go there at all.?
bank 1, KS-1
they are both mounted to the top of the bare engine block
they are Microphones, no loose bolts rattling up there
or loose cam chains.
the main intake manifold must be pulled. (takes skills)
facing engine bank 1 is right bank, cylinder 1 front there.
KS1 is on same bank.
left word below means drivers seat perspective
see below KS1 is on the right facing the engine
clear as day we see the intake manifold is gone.
FRONT Of car IS HERE X
it is big sandwich, remove the top things seen to get here.called gaining ACCESS to it.
KS- sensors can lie you (scannned)
chain on cam bad.
lifter collapsed
or worse, can happen, bent valves?
do you hear noise (bad) form the engine, even at idle parked.
NO MAN CAN GUESS YOUR SKILLS OR TOOLS
NOR WHY YOU LANDED HERE,
DWEEBS ON THE WWW INTERNET TOLD YOU?
but I did answer how. not tools ,just where it is and what must come off. the block.
do not break bolts (snap) removing them.
I use pen oil and heat and more tactics. ask
with 6mm bolts, there, it can be tedious. not wrecking those.
now the SM words told (pasted)
- Properly relieve the fuel system pressure.
- Disconnect the negative battery cable.
- Disconnect the air intake duct from the dual duct housing.
- Unplug the electrical connectors from the throttle body, the step motor AAC valve and the exhaust gas temperature sensor.
- Disconnect and label the hoses from the valve cover, the throttle body, the step motor AAC valve, the EGR control valve and the air cut valve.
- If the spark plug wires are in the way, disconnect them and move them aside. Disconnect the accelerator cable from the throttle body.
- Remove the upper intake manifold collector-to-intake manifold bolts, and lift the assembly from the intake manifold. Discard the gasket.
- Remove the lower intake manifold collector-to-intake manifold bolts, in sequence, and lift the assembly from the intake manifold. Discard the gasket.
- If the fuel injector assembly is in the way, perform the following procedures:
- Disconnect the electrical connectors from the fuel injectors.
- Disconnect the fuel injector assembly from the fuel lines.
- Remove the fuel rail-to-cylinder head bolts.
- Remove the fuel rail assembly from the engine.
Remove the intake manifold-to-engine bolts, in sequence, lift the intake manifold from the engine and discard the gasket.
see that arrow red, it is inTHERE
im told Olive OyL can get there , directly./(grin)
