Infiniti Cars & Trucks - Recent Questions, Troubleshooting & Support

Clean throttle body and Mass Airflow Sensor. Correct fuel and air mixture is not being recorded.

Infiniti Q45... • Answered on May 02, 2021

Usually, the fuse for the washer pump is incorporated with the wipers, so if your wipers work, fuse is probably good. Best way to check is with a simple test light. Just unplug the connector for the washer pump, and probe the terminals with a test light clipped to the negative terminal of the battery. Someone will need to hold the washer pump in the ON position, with key in ON, while you are testing for power. If there is power on one of the two wires to the pump, fuse is good, and power is good, so the washer pump is probably bad.

2006 Infiniti... • Answered on Apr 27, 2021

Possible causes Faulty Engine Control Module (ECM) Faulty ABS actuator and electric unit (control unit) Control Area Network (CAN) communication line Blown ECM fuses What does this mean? Tech notes The code means that the Anti-Lock Brake System (ABS) control unit has detected that there is a problem with the Engine Control Module (ECM). What does this mean? When is the code detected? Based on the signal from Engine Control Module (ECM), the Control Area Network (CAN)-Local Area Network (LAN) converter (CLC) judges that the engine control system is malfunctioning. Possible symptoms ABS Warning Light ON Scanner cannot access Engine Control Module (ECM) C1130 Infiniti Description ABS actuator and electric unit (control unit) and ECM exchange the engine signal with CAN communication line. Major engine components are malfunctioning. Read more:

2004 Infiniti... • Answered on Apr 15, 2021

there is two "boxes" right behind the battery on the pass. side fender well. take a small hammer or rubber mallot and "tap" the box farthest into the cowling. try starting the vehicle immediatly after. (be gentle as to not break the plastic box, but don't be affraid to give it a smack) lightly tap the CAN mounted directly on the fender behind these plastic boxes as well, if it starts replace CAN communication area network its a fancy name for another computer

2005 Infiniti... • Answered on Feb 02, 2021

Hi, i used this method to solve a similar problem on a 2000 solara. Here is the fix, remove one of the car battery terminals for a couple of mins (3-4mins). The reattach the battery terminal back. This would make your cd player and car clock reset. once you start your car you should be able to eject the cds. You'll just need to reprogram all your preset radio station.
On the clicking noise when you change gear, check the transmission fluid..

2006 Infiniti... • Answered on Nov 23, 2020

If you are getting power to the switch, make sure you are getting power to the motors when the switch is moved. If so, make sure the motors have a good ground. If not, check the fuse box. If you have power to the switch and the switch is sending power to the motor and the motor has a good ground. you have a bad motor. If you have power to the switch, but are not getting power to the motor, you have a bad switch. If you don't have power to the switch, you might have a bad fuse. If you don't have power to the fuse, you might need to check a wiring diagram to see what feed power to that circuit in the fuse box.

Infiniti Cars &... • Answered on Oct 22, 2020

Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Oct 15, 2020 • Infiniti G35 Cars & Trucks


This code is set when the transmission control module detects improper voltage at the torque converter clutch. This can be caused by low tranny fluid/dirty tranny fluid/defective torque converter clutch solenoid/electrical connections to from solenoid

2001 Infiniti... • Answered on Oct 01, 2020

First, on the rear hatch, there is an actuator. On FX, when you close the trunk, it kind of **** the hatch closed all the way. When you press lock on the remote, this same actuator locks it as well.
1) when you unlock the car from the inside, go back there and press the button to open the hatch door manually, do you here any noises?
2) Close all doors, go back close to the hatch button and using the remote , lock the car and then unlock the car. you should hear a sound from the actuator locking and unlocking the lock on the rear hatch!

If you don't hear this, your actuator is inop.
Next step would be to check the fuses inside the car, on the left bottom driver side, and outside on the battery compartment.
It might be just a fuse.
If all fuses check ok, your actuator is most likely gone! Not ea expensive fix, just time consuming!

NOW, if you can hear the noises, then something is either broken inside the actuator or one of the cables is loose!
Hope that helps.
Also, what year and miles on your fx?

2004 Infiniti... • Answered on Aug 22, 2020

It's fuse #41 in the under hood fuse block,

Infiniti Cars &... • Answered on Jul 20, 2020

Quit guessing and have ABS codes read. Symptoms would be indicative of a bad wheel sensor which often fail with hub/CV failures.

Infiniti Cars &... • Answered on Jun 20, 2020 This thread has several suggestions from a failing battery to bad grounds or BCM problems.

Infiniti Cars &... • Answered on Jun 01, 2020

If the radio is not correctly working or does not start at all, check the following fuse: • In the passenger compartment fuse box - Fuse number 6 which is a 10 Amp fuse • In the engine compartment - check fuse box number one. In it, there will be fuse number 37, a 15 Amp fuse, replace it. To know more about all the fuses in your car and what each does, follow this link:

2005 Infiniti... • Answered on May 21, 2020

Not finding what you are looking for?
Infiniti Logo

Family Lines

4,843 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2005 Infiniti G35
2005 Infiniti G35

344 Questions

2004 Infiniti I35
2004 Infiniti I35

181 Questions

2004 Infiniti FX35
2004 Infiniti FX35

143 Questions

2006 Infiniti M35
2006 Infiniti M35

149 Questions

2004 Infiniti QX4
2004 Infiniti QX4

86 Questions

Top Infiniti Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

14869 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6647 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides