t snapp posted a question about Washing Machines:
"Location of water vavle on maytag mfi2569"
t snapp posted an answer for this Maytag Dependable Care LAT9706:
"maytags web site, you will need the tub bearing and boot seal kit, get it fixed it is..."
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"you have a bad touchpad"
t snapp posted an answer for this Maytag Neptune MAH9700A High Efficiency Front Loading Washer:
"Your board is not sending signal to the pump to drain"
t snapp posted an answer for this Maytag Washing Machines:
"door open=do bad door switch"
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"bad door lock assembly Indent" class="redactor_btn redactor_btn_indent"..."
t snapp posted an answer for this Maytag NFW7200TW Front Load Washer:
"take back offand check pump for objects"
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"rear bearing bad , cost exceeds valve of machine , run it till it stops ."
t snapp posted an answer for this Maytag Neptune FAV6800AW Top Load Washer:
"you need to feel under front lip of soap door and pull green line to unlock"
t snapp posted an answer for this Maytag Dryers:
"You need to replace coils on gas valve"
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"nf =not filling , not enough water to machine"
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"this model has issues with control , clicks then flashes"
t snapp posted a question about Maytag MFI2266AE Side by Side Bottom Freezer French Door Refrigerator:
"freezes in frig"
t snapp posted an answer for this Maytag Dependable Care LAT9206:
"I would look at lid switch on this model and plunger to lid .Under lid is spray flume that..."
t snapp posted an answer for this Maytag Washing Machines:
"This machines timer is bad ,basically you have bad contacts in the timer ,that why it only..."
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"If it does not fill it will be a upper control board . Does it feel your touch if not the..."
t snapp posted an answer for this Amana Washing Machines:
"If we are talking about a front loader it is going to be a broken spinner or bolt holding..."
t snapp posted an answer for this Bosch Axxis WFL 2060 Front Load Washer:
"take top off at back and check valve ,it should be at the top . Also check front rubber..."
t snapp posted an answer for this Crosley CAWC529JQ Top Load Washer:
"Clutch is only used locking into spinout. Is drive coupling is loose or torn, if not you..."
t snapp posted an answer for this Maytag Neptune MAH5500B Front Load Washer:
"rear bearing part only 500."
t snapp posted an answer for this Maytag Bravos MTW6600T Top Load Washer:
"early model that bearing goes out in , but 1300. to replace with new machine i fixed mine ..."
t snapp posted an answer for this Maytag Washing Machines:
"check your inlet valve screens"
t snapp posted an answer for this Maytag SAV515DE Top Load Washer:
"save your money this is one major lemon, bearing goes bad in all of these pos"
t snapp posted an answer for this Maytag Washing Machines:
"bad tub bearing"
t snapp posted an answer for this Maytag Washing Machines:
"you are correct spin bearing bad"
t snapp posted an answer for this Maytag Bravos 3.8 Cu. Ft. Washer:
"spinout bearing bad if noisey in spin only whole tub must be repaired"
t snapp posted an answer for this Maytag Washing Machines:
"long drain times"
t snapp posted an answer for this Maytag Washing Machines:
"top comes off with clips and should be able to reach in between tubs"