Lenoxx Electronics Audio Players & Recorders - Recent Questions, Troubleshooting & Support

HelloThe sled motor of your player is not working. This is the motor that spins the disc inside as soon as it has been loaded. But to spin disc, the disc must be loaded properly into the loading mechanism. Just check the loading belt that attached with loading motor and loading gear set for any loose, which may cause improper disc loading. Replace it first. If it does not help you, check the voltage at the seled motor terminals. There must be a voltage [4.5VDC approx:]. If the voltage is there and still the sled motor does nor work, replace it. If voltage is not there, the fault is with the loading IC which is soldered to the main board of the device. OK>

To Set the alarm time: Press and hold the ALARM button down, and then press the hour/minute buttons to obtain desired time (Note the PM indicator on the screen for PM times)

To Enable the alarm: Move the sliding switch to AUTO or ALARM (Auto is for radio wake and Alarm is for beeping noise) *remember to turn up the volume knob if using AUTO (radio) setting.

My model CD-88 programmable compact disc player player will go around but no music comes from it. It is one that you can use in your car tape player as it has an adapter. What is wrong with it ? Thank you. Estella Huffman [email protected]

http://www.retrevo.com/support/Lenoxx-CD-160-Boomboxes-manual/id/22975ag222/t/2/

You might find your unit here:

http://www.retrevo.com/samples/Lenoxx-manuals.html#Radio

http://www.retrevo.com/samples/Lenoxx-CD-Player-manuals.html

http://www.retrevo.com/search?q=Lenoxx+Electronics+CDR-190

Page 1 and 8

Basically, hold the time button and adjust the hour and minute; hold the alarm button and adjust the hour and minute using the buttons.

The manual:

http://www.retrevo.com/support/Lenoxx-CDR-190-Clock-Radios-manual/id/22975ci174/t/2/

Hold the Time Button down,

and press the Hour Button,

until the right hour time shows
in the display.

Hold the Time Button down,

and press the Minute Button

until the right minute time
shows in the display.

Likely a bad backup battery inside the clock, or a capacitor that is leaking a charge.

itll be the lens on the player clean it with surgical spirit

You need to open it up to check the parts inside. First look around to see if there is any plastic parts that are damaged. This might account for the noises inside. If you can not see anything wrong. Get a magnifying glass or lens and look at the lazer lens. Make certain the power is NOT on for any of these tests. If you see any odd light patterns or damage on the lazer lens it will not play discs. Unless it was an expensive model it will not be worth repairing if the lens is damaged. Do not open the unit if the model is still under warranty. In which case contact the maker of the unit.

the latch inb the back of ther speaker Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

There is a latch on the middle back Tony Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

http://www.studiosoundelectronics.com/cassette.htmYou can remove the damaged one and measure it and this site on the link above provides generic replacement

Does the back of the CD player use either of these cords? If so you can find them right here 483results for PS2 power cord or 28results for PS2 fat power cord

Does the back of the CD player use either of these cords? If so you can find them right here 483results for PS2 power cord or 28results for PS2 fat power cord

Do you think any of these would work? 5results for ghetto blaster replacement antenna

There is a pretty good chance that this boombox uses the same plugs as sony so you should check their PS2 fat cables and their PS2 power brick cables to see if any of those match. Ps2 power cords