Questions & Answers for: water temp gauge working 1999

water temp gauge stopped working I have replaced the thermostat and thermostat sensor in my 1994 ranger 4.0 ,but the gauge worked for a while but now the needle does not work. I see that there are two

temp gauge pegs left and a/c when runs overheats engine ford 2001 ranger xlt 2.3lt (standard) temp gauge will move slightly as engine starts over heating start missing as heating goes up loss of power

...my speedometer, gas gauge, temp and battery gauge are not working on my 2001 Ford Ranger XLT. However, the gas gauge and oil temp gauge are still working. What could be causing this? sounds like a ...

my 1992 ford ranger temp gauge does not work check sensors and gauge conections failing that test sensor

...working what could be wrong If the temp / fuel gauges work then it just might be chance, just check you fuses first with a proper 12 v test light, Failing that did you disconnect the battery for any ...

...water temp gauge. All is connected. What now? you should switch the temperature sensor and oil pressure sensor you had on your first engine,because your new engine must come with the light indicator ...

ford ranger volt, temp and gas gauges don;t work and speedometer is off 93 ford ranger. the volt, temp and fuel gauges do not work. fuse is fine. should gauges be replaced or can they be tested? also,

...temp gauge doesn't work, speedometer doesn't work until it gets to 30 mph, and rough idle in the mornings. could all this be the result of a bad computer? A/C doesn't work, temp gauge, speedometer ...

...1995 Ford Ranger 2.L temperature gauge sensor ? 1995 Ford Ranger 2.3 L The water temp sender is 22 in the picture, close to the oil filter. One wire connector, wire color, red with a white

...is more like warm and then kinds of goes away and warms, what could it be?? Weak water pump or plugged heater core. The temp gauge shows normal? Can also be air in system,but probably not. ...