...99 Ford Ranger Looking for the timing mark locations for a 1999 Ford Ranger 3.0. I found the teeth on the balancer and the marks on the crankshaft pulley-but no pointer to set them to. Trying to ...
...test that my Haynes manual showed. Can the crank angle sensor or one of the other sensors cause this problem? yes the crank angle sensor can couse and but some time the coil test ant always right ...
...crank sensor, have replaced cam sensor, have replaced coil pack, have checked for camshaft turning,have noid tested injector harness, originally started to act up a year ago. Developed to needing to ...
...test. have the crank sensor check for erratic operation. if you have done all of that then there is nothing else. and they way the computer knows it is misfiring (if it is) false code maybe and could ...
...up, have changed out, crank shaft sensor, mass air flow sensor, egr, and computer. And also ran fuel pressure check Any suggestions? do a compression test on all cylinders, check all 4 spark
Question about 1995 Ranger Supercab
...the crank shaft posiction sensor, or the Cam shaft synchro do you have any codes? prior to this? the CSS Is know to come apart on fords, happened to me about a moth ago on my 99 taraus. hope this ...
...when stopped get the following tests done ,compression test ,engine management code read and injector tests. sounds like a fuel problem like a leak or pump pressure also could be timing or crank ...
Question about 1992 Ranger
...crank sensor, the ignition module. ive posted this 100s of times, ill condense it. 92 ranger,OLD. 50 causes (parts) its caused by misfire, so bad it stalls. 1 cause) 5 reasoins if physics and simple ...
Question about 1998 Ranger
...stay running we change crank sensor and timing belt truck has spark Have you tested fuel pressure using a test gauge? Are the timing marks aligned right ? Did it run before you replaced timing belt
Question about 1998 Ranger
...crank sensor and cam sensor , coil packs and ignition switch also fuel filter Did you check for battery voltage to the coils ? Check for control from the PCM - engine computer . You probably should ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions