Questions & Answers for: swing arm bushings

Question about 2001 Escape

1 Answer

...arm. hi there this is a problem with all shocks and swing arms where the bolt goes through a rubber bushing and the water and road salt debris gets into bushing and freezes up causing the bolt to ...

Ad

...swing arm bushings or bearings, swing arm bearing preload, worn defective shock, bent frame, rims. forks. misaligned forks. fork stiction. Prevention is in making all above are correct., a steering ...

Ad

Question about 2000 FLHTCUI Electra Glide Ultra Classic

1 Answer

...Not sure what you are asking? The wheel alignment should align when you adjust your belt deflection by the axle cam.Unless you have changed the swing arm or any bearings or bushing in the swing

Question about SSR 110CC Pro Beginner Bike

1 Answer

...swing arm removal the swing arm axile appears to be fixed internally with clip key etc. IS IT? IF SO HOW DO YOU REMOVE IT/ At the moment with the retaining nuts removed it floats about half inch. ...

Question about 2003 FXD Dyna Super Glide

1 Answer

swing arm wobbles 2003 FXD high speed wobbles If the swingarm wobbles from side to side, you need to replace the swing arm bushings. You'll have to support the engine/transmission while you remove the

Question about 1989 XJ 600

1 Answer

...swing arm to see if it moves or wiggles at the pivot points. You probably have bad swing arm bearings. If the swing arm bearings are bad you will probably have to change both bearings and the long ...

Question about 1989 XJ 600

1 Answer

swing arm moves from side to side. If this is the case you also need new swing arm bushings. Another sign that the swing arm bushings are bad is if the chain is banging against the swing arm while you

Question about 1997 XLR 125 R

1 Answer

swing arm bush Swingarm Bushings to get the swingarm bushings changed out, you just have to remove the rear wheel, unbolt the lower shock mounts and chain guard, then pull out the swingarm bolt

Question about 2009 FXDC Dyna Super Glide Custom

1 Answer

should there be & could I make a bushing out of molebdenum? Lay the bike on its side. Superglue the bush to the swing arm. Lay the bike over the other way and repeat. Do not glue the bush to the shaft

swing arm after istalling it i have a gap on the left rear drivers side and a little gap on the passenger rear side check that you installed the bearings /bushes in the swing arm correctly. check that

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...