Questions & Answers for: steering shaft slack

...above gear box on shaft that goes to steering wheel, while some one turn's wheel a little back & forth and check for slack, Also check front end linkage for looseness, don't forget wheel

Ad

...steering shaft is worn. How do I repair it with more sustainable solution. Thank you Michael replace steering gear and lower nyliner bushings on steering shaft. Also check sector gear for wear and ...

Ad

steering shaft where it connects to the cab steering & the steering gear box and took the rag joint off by drilling the rivets out. The local parts store ordered the wrong part, so I just ended up

Question about 2003 Alero

1 Answer

...I have seen racks come loose on aleros and grand am's. Did you replace the inner tie rod ends, they may also be worn, you also have a small U joint on your steering shaft. I hope this all

...shaft at the steering box with a wrench or channel locks, have someone get in and turn the wheel. If the wheel turns and the shaft doesn't, then your problem (or at least part of it) is in the ...

...steering boxes, you adjust the end play on the sctor shaft on top of the box with the wheels up off the ground, make sure that there are no tight spots when you spin the steering wheel from lock to ...

Question about 2004 Escalade

1 Answer

...steering play ,new gear box adjusted good ,idler arm replaced and bracket,going to put in intermediate shaft in and the lower shaft going into the gearbox ,but is there a hydroboost issue with these ...

Question about 2004 Escalade

1 Answer

steering shaft down to where it connects with the steering knuckle and/or front wheel link bar. Try twisting and jerking each individual piece snugly to look for slack. I would venture to say that the

...Steering Linkage Installer J 45341 Rear Wheel Drive Shaft Removal Tool SA91100C Tie Rod Separator SA91112T Axle Seal Protector SA9173G Slide Hammer Removal Procedure Raise and support the vehicle. ...

Question about 2004 VUE

2 Answers

steering where the shaft connects to the rack ..replaced ball joints control arms tie rods an the rack an the shocks started after u did all that feels like it getting worse Try adjusting the steering

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...