...work. Look at the bottom of the dash by the steering column,you will need to remove the cover acouple of screws.Behind the plastic part of the dash you should see a black module labled keyless
...steering column no, you have to have the switch in the on position, you either have to drill the ignition out (1/2" drillbit) or chisel the tumblers out of the cylinder... using excessive force may ...
...steering column bearings I replaced the bearings in my steering column,but i can't get the spring and clip on the column in front of the bearing.Is there a special tool i need? thanks pete There is a ...
I need to find out where the ignition switch is located on a 1997 ford f150 4x4 right side of steering column
1997 ford 150 for about 1 month stared it today now my wipers and power window s don't work anymore. Check for water intrusion into the fuse box on the driver's side to the left of the steering column
steering column and look for the ignition box/cylinder. most of them have a locking pin and some may have screws. depends on your car. but look there it should be cylindrical on fords and have a bunch
1997 ford f150 steering wheel is lose its not the tilt steering thats lose just the steering wheel itself it wiggles up and down Upper or lower column bearings probably worn.
Battery drain, altinator not charging and gauges not working. Check and the ignition switch, sounds like it needs to be replaced, should be on lower side of the steering column.
may have a defective ignition starter switch, it is located down on the tube of the steering column, very easy and cheap to replace. See picture below of switch assembly Color of switch may vary
...1997 Ford F150 the wipers work until you put into gear and the wipers stop.. You have a bad connection probably the ground side in the wiper section or steering column if they are mounted on the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions