Questions & Answers for: splin

worn front drive shaft does the front drive shaft turn when not in 4wd on a 1998 chevy truck. The front drive shaft is worn where it is splinned together which might be causing vibration. no only the ...

...exsposing a nut, should be a 13 or 15 mm. Loosen the nut, flip the arm up and wiggle it. It is on a splin shaft. Sometimes they can be a buger to get off. Make sure when you reinstall the new one to ...

...some help. Put it in gear. One of you look under it see if the drive line is turning. if it is. The splin in the rear end -Where the big nut is. may be broke. mine did. If it don't turn. It broke the ...

cv axles how do i take the splin end that goes into the hub off remove the outer bolt. undo the 14mm cold that holds the ball joint in and get a pry bar and pry the ball joint out and the cv should ...

Do you have to remove the steering wheel to change the turn signal lever on the 94 c1500? 5.0 engine with cruise control. My wipers will not turn off when I turn the switch off. It acts like a short ...

I had my power steering box rebuild as the splins on the input shaft striped and now the vehicle turns ok to left but very hard to right side as if no power steering Your steering box was not ...

...half way up winshield ..I pushed them down & now they dont work at all..is it the fuse or the splin e on the arm or the motor? how or what do i check 1st check fuses and ...

how to get cv shaft out Remove Wheel Remove Lower Control Arm Joint Pull Stub Axle Outward Remove Nut Holding Splinned Shaft ,Remove Shaft ,Pull Shaft Out Of Gear Box, Clips In May Need A Good Clout ...

Why is it grinding and won't go into park or pull after changing cv boot? I put a cv boot on the pass side of this car and drove it and it done fine. Today I put a CV boot on the driver's side and now

I just got a Murray Spindle Housing, and Splin Shaft. How to put together ? Mc Givers Workshop will help with that