Questions & Answers for: speed sensor 95 blazer

...95 chevy blazer with a 4.3 litre engine. It has a high idle. It runs at 1200 when starting in the morning and around 1700 when engine is warm. Today i totally blocked the air intake and it didn't ...

sensor while its running the light will come on. What should i do. I'm at a loss. someone help me before i throw a thousand bucks into a lake at full speed. I am going through the same type of problem

Any suggestions??? Try changing your oil and filter, and your modualator valve or shift solenoid. I have to admit i'm not sure which your's has, and i don't have a book with me right now. Speed sensor

...speed it has been running very slugish ,also Ive changed the pulgs and cap and rotor why would it still be running slugish Replace the fuel filter and clean the MAF sensor with MAF cleaner. Just ...

...sensor and the switch connector. 1. Remove switch connector and jump connector terminals. If blower now operates, replace switch. If not..... you have either a resistor failure in the resistor ...

speed 6cyl with vortec. it pretty hard when i try to change gears, it just happend over a couple days i know the clutch is good could it be a sensor. even when its in 1st gear i have the clutch peddle

...Speed Sensor Mounting Surface) Models:1999-2000 Cadillac Escalade1995-1999 Chevrolet Silverado (Old Style)1995-2000 Chevrolet Suburban, Tahoe (Old Style)1995-2003 Chevrolet Astro Van, Blazer, ...

speed sensor as for engine cutting off sounds like a low fuel pressure problem.Check the fuel pressure it should be 60-66 psi with the key on engine off.Also check the fuel pressure regulator for

speed on take off. It feels like its dragging and its burning alot of gas. I already cleaned the EGR. Got a new distributor and a new position sensor.. I have not done the fuel filter yet. but I still

Could be a bad ABS (wheel speed sensor) or if slack in one of the front wheel bearing. Have your Blazer scanned and should tell you which wheel it is. If it's the front, check for slack in the bearing