Questions & Answers for: solid state ignition work

...solid state relay that controls it along with the module. The 3 fuses are no. 109(50amp) in the battery junction box under hood.This is the direct feed to compressor thru the solid state relay. The ...

...solid not blinking Check your flasher, should be some wear near the fuse box It would seem that your flasher unit has failed in the ''on'' state. The reason it stays on when the ignition is off is ...

solid-state switch (ignition module). Another way of looking at the solid-state switch is to think of it as a relay. When voltage is applied, the relay is energized. With no voltage applied, the relay

what is the correct gap between flywheel and solid state ignition I just use a paper machbook cover has worked every time for me

...the kill switch, eigther at the ignition unit or at the switch itself (on the handle). If still no spark the ignition unit is bad. These are solid state they work or they don't. Hope this

solid state circuits that control different functions, like the fuel injection or the ignition. You need to isolate which system is not working and then replace the module for that system. If you have

...solid state ignition system. Harley went to a solid state ignition in their Big Twin engines in 1979. If your's has points in it, it has been converted to that system. So, I'll simply explain ...

...solid state ignition work only starts once in a while Its a magneto. Requires no outside power source. Remove the black wire from the ignition coil and check for spark. If you have spark the coil is ...

...solid state ignition system on your engine. On today's engines these ignition modules either work or, do not work and will need to be replaced. In other words, they produce spark if they are good or, ...

...solid state circuit located inside the switch supplies ignition voltage to the lamps. The solid state circuit also receives voltage whenever the headlamp switch is in park or headlamp position. When ...