Questions & Answers for: soft close doors longer closing

...soft click - sort of like a relay resetting. It may have come from the VSM/BSM. It may have possibly been a stuck actuator releasing. I don't think so. It wasn't that load. In any case, everything is ...

...soft. I set the freezer lower ( to -27) and it seemed to have little effect even after 6 hours. Ice in the ice maker is still frozen and so are the items except the ice cream. All items in the food ...

soft while others were rock hard. Defrosted & refilled. Now it runs continually with dial set between 4 & 5. Temp in freezer is just above zero. There is a percolating/gurgling sound always as

...soft when lifting it and I have to lift the handle on the outside any physically move the finger arm mechanism up to get the door to close aroung the pin on the frame of the vehicle. Can someone tell ...

...soft food disposer isn't made to act like a garbage disposer, but rather, to catch incidental food residues. We no longer fill the closed detergent dispenser. We sprinkle about 1/2 of the normal ...

...doors and let warm moist air into the cabinet 5. Is the condenser clean, this is the small radiator on the end of the cabinet, clean it gently in line with the fins with a soft brush and vacuum ...

...soft. Hi, Thank you for contacting fixya.com. There are various reasons why a refrigerator keeps on running. The motor will run longer under warm conditions or if the refrigerator is receiving direct ...

...just clean the screen with a soft brisstled brush and water, then test again. It is the dryer sheets that close up the screen openings and if bad enough can even cause an overload/overheat

...Soft Reset. Save your work and close all active programs and games.End wireless connectivity by holding down the red "End" button for 5 seconds.Take off the battery door cover.Remove the battery from ...

...close the door. The light should go off with the door shut. If the video shows that the light stayed on when the door was closed ... then it reinforces that something is wrong with the switch/alarm. ...