Sanyo Pro xtra projector - warning light Hi we have a new ( 2 week old) projector. When we turn it on the green light appears and it seems to be turning on. After about 15 seconds the warning light ...
Question about PLC XU35 Multimedia Projector
...Sanyo Pro Xtra X Multiverse Projector Hello, I am planning on giving a power point pres. using my lap top computer and the Sanyo Projector, however I cannot get a signal. I connected my LCD monitor ...
Sanyo Pro Xtra's that are used about 30 hours per week and have both blown their lamps within 7 months. What would cause this? They are mounted upside down and about 25 feet high with no obstructions.
Sanyo Pro xtra x mulitverse projector on one day and the image is skewed to the right. The projector is mounted to the ceiling and immovable. I tried thigns on the remote, but got nowhere. sounds like
Question about PLC XU35 Multimedia Projector
SANYO PRO XTRA X MUTLIVERSE PROJECTOR SHOWS FILTER FAULT YELLOW LIGHT ON START UP AND YELLOW MESSAGE ON PROJECTION SREEN clean filter
...xtra.co.nz with a possible direction. Thanks Before Hand the green light is all bent and out of focus. i see a double picture. Your TV most likely a convergence failure. ( common problem ) Here are ...
...incorrect on sanyo pro xtra x projector reset to factory default settings (from the menu). after that if it's not where you want them, you can go into the menu and set them to where you like
Question about PLC XU50 Multimedia Projector
...SANYO PRO xtra multiverse projector" goes off after there has been "SANYO" image in approximately 25 seconds. Here, after the projector turns off the image and the Power button flashes ...
sanyo pro xtra projector, connected to my laptop and put the power plug in. Why is there no projection? The power light is flashing on/off orange. Is this correct?: There is no manual Try reducing the
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions