...door, remove the toner/drum unit and replace the transfer roller. Replace the feed roller and friction pad. Then switch on the printer. If you need more info, please let me know. Good luck and please ...
...roller that keeps the surface of the Imaging Drum clean and oiled. NOTE: Order a new maintenance kit when the Display Screen displays a message that the maintenance kit is low. Replace the kit when ...
...roller for the paper tray mechanism. Unfortunately dell in the UK do not sell maintenance kits to the public, and therefor ehte only place I found them wa on Ebay in the USA. The kit in quetsion is ...
...door. If it isn't getting out of the tray you may coincidently have a smoothe feed roller, if it is feedinf a couple of inches out of the tray and stopping in the lower rollers I suspect a slipping ...
...kit usually only includes the maintenance roller,what is yours coming with. The maintenance roller is taking out from the right side there is a little door there that opens and its an orangeish ...
...Roller." As dust builds up on the rubber rollers, they become less tacky and therefore unable to grab a single sheet of paper. To prevent and/or cure this type of paper feed problem, these rubber ...
Question about Aficio SP C410DN Laser Printer
...remove paper fully--- under the printer move lever to the right and remove the feed roller(do not turn the printer upsidedown) transfer roller -- front door--- press 2 green locks and pull unit ...
door open. 3.Lightly moisten a lint-free cloth with water. IMPORTANT:Do not use cotton or cotton swabs to clean the paper feed roller. 4.Use the moistened cloth to gently wipe clean the surface of the
...door out and then remove the fuser by pressing the two blue tabs on either side. Look closely at the two rollers inside the fuser by looking at the side that faces into the printer. Chances are that ...
Question about LaserJet 9000 (C9152A) Maintenance Kit (C9152A) Maintenance / Upgrade Kit
13.20 paper jam 13.20 at star up Is this the right door jam? If so, have you checked the pick-up rollers. I had this happen on a machine after I had changed the rollers, but didn't get one of them ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions