Questions & Answers for: reset quot change oil message

change Oil message light Just bought a 2000 Tahoe and changed the oil. Don't have a manual. How do I get the change oil light to go off? With the ignition on, Motor Not Running, fully depress the ...

reset change engine oil 2000 model chevrolet venture . With the ignition key in RUN but the engine off, repeatedly push the trip/reset button until OIL is displayed on the Driver Information Center. 2

reset change oil message on a 2003 chevy tahoe thats an easy one, turn the key to run but do not start the truck. push the gas all the way to the floor and let it back up 3 times withing 5 seconds and

...reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the Message Center, press the SET UP control to access the System Check mode. Press and release the RESET button to display ?OIL LIFE % HOLD RESET ...

...i reset oil change. just need to know the procedure/button to reset after oil change If it is not reset by the information center, you turn the key on and pump gas pedal three times.this will reset ...

...reset the change engine oil light on a 2003 chevy tahoe Turn your key to the on position(do not start), then push the throttle pedal to the floor three times, turn of the ignition, wait a second or ...

...quot; messages. I did the work but the messages still need to be removed. HELP!! Look for the Information Center panel above the Audio controls.. There should be 4 buttons labeled Fuel, Setup, Reset, ...

...reset oil change ligth after oilchange According with the repair guide, to reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the Message Center, press the STATUS control to access the System Check ...

it turned off!!! it said OIL CHANGE RESET, it also worked in the 2004 Chevy Corvette, thanks for the help it is NOT in the Manual, I looked through both manuals and threw them across the living room :

...reset oil life to 100% 6. Message center will briefly display OIL CHANGE SET TO 100% With a message center cluster the procedure is as follows: 1. press and release SETUP button until message center ...