...power steering works). E52 is a PCM (engine computer) memory reset code. Have you disconnected the battery of late? If not, check all your fuses. One of the fuses for the PCM may have blown. ...
...symptom. oh yea and of course i cleared the computer first but the same code pops back up can u tell me why? Have your Juel Pump and Filter Changed. and then reset your Computer again. Should fix
...reset ! didn't work . thanks rusty. I've not done this for the reason you speak of, but I was told to disconnect the battery from both terminals and hook the 2 cables together and leave it that way ...
...Call your local dealer to find out where the switch is. Also try disconnecting your battery for about 20 minutes to reset the computer (it may recognize that there is now fuel in the
...the battery for approximately 30 minutes and it may reset. If not, luckily these model are pretty easy to come by in the junk yards, and pretty cheap, so i would grab a new computer and plug it
...reset the computer after changing the oil myself ? The change oil light comes on for about 30 seconds before going out. The motor is a 4.9L. Thank you... Depress and hold RANGE and FUEL USED buttons ...
...reset the computer.. it appears that it has solved the problem. It starts up and goes right to 750 rpm and stays there,, it runs well on partial throttle , but sometimes under hard throttle it "bogs: ...
...COMPUTER . IF YOU DRIVE IT AROUND FOR FIFTEEN MINUTES TRY TO GET IT OVER 30 MPH AT 1 POINT , ALL THE PERPETRATORS SHOULD BE SET, AND IT SHOULD RUN NORMALY. IF THE CODE COMES UP AGAIN, I THINK THATS ...
how do i reset the computer after chaning the oil Push the reset and range buttons at the same time on the fuel data center.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
