...I do now? Optional Information: 2004 Ford Escape V-6 3.0 liter Wen you put back the battery on i think that you mist a groud wire that was on your groud cable or a power wire +try this and good ...
...alternator. Disconnect the battery and cables from the alternator. Replace with new alternator and hook up the power cables to it. Then reconnect the battery and you're done. Mike. Rate 100%
...replace a blown engine on a 2005 ford escape and it won't start. Starter works just makes clicking noise. Does this have anything to do with the engine immobalizer? Check battery cables for corrosion ...
replace the battery and the start, the starter is still dragging like it dont have enough power to turn it over. what could it be. please help if u can. thanx kyle run another earth cable from battery
replace the ground cable on a 2002 ford escape? you can buy them at autozone just figure out your cable lengh unbolt the old one from battery teminal and follow it to were it is bolted and repalace if
...didn't clear the code. How do I clear it off? remove the positive battery cable from battery and wait half hour , put back on . this will reset your on board computer and remove all ...
Question about 2010 Escape XLT
...to me like there is LOTS of voltage, however the amperage isn't enough to drive the solenoid. Do a load test on your battery before you go replacing parts you don't need to. -Steve REPLACE ...
Question about 2004 Escape
...replace the main ground cable on the battery with the same kind if so do you have the part # You can remove the end of the cable from ground and remove other end from battery,take to Autozone and ...
Question about 2004 Escape Limited
...battery cable ? i replaced old battery with new one now the only way my ignition will lock is for me to disconnect neg cable why is this were i suppoxe to reset something The transmission position ...
Question about 2004 Escape Limited
...positive battery cable on 2004 ford escape xls 6 cyl. spliced battery cable and ground wire but no turn, no crank, no start, nothing. what did i do wrong? Splicing the cables rather than replacing ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions