Questions & Answers for: replace battery cable chevy suburban

...battery cable on 94 suburban I am changing battery cable on my 94 Suburban. I have replacement cable from chevy dealer. It is actually 3 cables in one. I can track where one goes to the alternator, ...

...battery cable. Detach the sensor harness connector at the sensor. Unfasten the retaining bolt, then remove the sensor from the front cover. Inspect the sensor O-ring for wear, cracks or leakage and ...

...checked the battery, the starter motor, the battery cables have been replaced, the ignition switch. I have jumped the solenoid switch and the truck still does the clicking? replace the starter ...

...replace the starter on a 2002 chevy suburban wtih 4 wheel drive First you need to raise the truck off the ground and put it on jack stands.Remove the battery cable negative cable end.Next step is to ...

...chevy suburbani have no electrical power,my lights n radio come on but when try to start nothin happens just my battery gauge goes frm 13pwr to 0pwr..wat is wrong? Sounds like the battery cables are ...

replace heater blower motor in 1989 Chevy Suburban? Disconnect the negative battery cable. Disconnect the blower motor lead connector from the wiring harness connector. Remove the blower motor cooling

...battery cable plus post, goes to the starter, Minus post to a good ground, like the engine. If wiring is ok, then look at the starter solenoid for a good connection. Problem is most likely the ...

...battery cable and the battery's hole. There is a copper ground connector on the positve side, but it also doesn't meet flush up against the battery. Never heard of that, but if the bolt is too long ...

...is not regulating the alternator to battery what could it be check the cable coming from the back of the alternater going to the battery make sure it has current flowing throw it if not replace ...

...replace my my Suburban in the last year or so!) First try disconnecting the battery cables from the posts on the battery and clean the connections really well with some steel wool or a wire brush. It ...