Questions & Answers for: removing driver side axle 2001

2001 intrepid cv joint removal and replacement getting a growling sound from right front,more so when steering left? bearings make growling noises and axles cv joints make a flutter vibration when ...

axle). Make sure if you are doing both that you take care which side you are installing. I made that mistake and double the work. Slide the new axle on the spline and make sure it is seated completely

...do i bypass security on Dodge intrepid 2001 on a 3.2 engine You need a 680 ohm resistor. one side connect to ground the other side connect to the light green with orange wire in drivers door ...

...intrepid axle shaft 2003 dodge intrepid remove tire/wheel and remove axle nut!! i thinks its a 32 mm socket and then take the upper strut bolts out of the knuckle theres 2 bolts 18mm if not there 15 ...

...side axle is holding the tranny up. how do i remove it? or what else could be done? Sometimes the axles on these do hang up. The best way to remove these is to take 2 pry bars to place on either side ...

side of the trans axle case below the shift lever and above the stub shaft.Both should unscrew from the trans axle case.These sensors are not interchangeable.If they are removed be sure to replace the

side axle. axle on passenger went back into transmission with no problem. Drivers side (new axle) will not lock into transmission.There is a ring on the end of the axle of shaft. Put both old axle and

...removing the tranny from an Escort in a Pic-A-Part yard. The axle nut is proving to be extremely difficult. I was told that it wasn't necessary to remove the cv axle, that - if it's loose from the ...

...driver's side Search for that on YouTube.com entering your cR info an cv axel Remove the tire, remove the axle nut, Remove the lower ball joint nut, remove the lower ball joint out of the spindle. ...

...2001 Intrepid Dodge? How to remove right drive shaft..? They pop out. Pry bar does it. Start with a screwdriver if needed. Doing it on the ground is a pain. You may want to remove the axle bracket. ...