where necessary. Before installing your valve cover is a good time to check your rocker arm clearances. This is also a good time to replace your drivebelt, and any other maintenance items as necessary
...removed the valve cover, letting me see the crack in the cylinder head, appx. 1/2 way across the head. I do have water in the oil, the engine sounds fine, no skipping or irregular sound, so I believe ...
...rocker assembly. two turns at a time on every bolt till there all lose fift as unit be care full or it can fall a part in few dozen pieces. This may only need to be done if you have something hitting ...
...ROCKER ARMS remove the inner head bolts 9 bolts 5/8 heads (7 long bolt 2 short ) and the 8 lower bolts on the back of the head are the ground cables to the computer one per side some also has a ...
Question about 1999 Tahoe
...removed rocker arm assembly and did not line up timing marks did i waste the car 2005 dodge neon sxt i di not line up TDC before doing this- i tried to set TDC at this point i did not take off the ...
Question about 1999 Tahoe
...removed rocker arm assembly and did not line up timing marks did i waste the car 2005 dodge neon sxt i removed exhaust rocker arm assembly only, i did not put engine to tdc first and then tried to ...
Question about 1996 Grand Cherokee
...removed. (3) Install rocker arm and pivot assemblies in the same order as removed. Tighten the rocker arm bolts to 28 N·m (21 ft. lbs.) torque. CAUTION: DO NOT rotate or crank the engine during or ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions