...from the right front side, next remove the plastic splash shield and from there you will see the tensioner pulley and adjuster bolt. Loosen the nut first and then you turn the adjuster bolt. ...
...tension, then remove the drive belt. To install: Install drive belt (A). Route the belt over the components in the following order: Crankshaft pulley → A/C pulley → idler pulley ...
...tension located on a 2003 Kia Sedona? The 1 is under the power steering pump, you'll need to loosen the nut in the center of the pulley and there is an adjuster bolt that when loosened moves the ...
...2003 kia sedona mini van You'll need to loosen the belt tensioner. Unbolt the 2 lines going to the compressor, unplug the electrical connector at the compressor. Remove the 4 bolts holding the ...
...Remove the bolt that retains the sensor in place. Remove the sensor from its mounting. To install: Installation is the reverse of the removal procedure. Clearance between the sensor and the sensor ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions