...old one out and the new one in? Will I have to pull the motor out? hey Remove the bolt in the crankshaft then use a puller to remove the rest of the balancer. Sometimes they come off without a
Question about 2002 Stratus
...remove the crankshaft. Is there any other way of gettin it off without it. If not does anyone know where I can find this tool. I think you mean the harmonic balancer, which is the pulley mounted at ...
remove the crankshaft pulley bolt(s). There are alternatives to stabilizing the crank -- I sometimes just put a piece of 1x2 lumber under the belt going around the crank pulley. An air (impact) wrench
...a puller to safely pull, without damaging, the pulley off the crankshaft. When it gets pulled away, off the crankshaft, remove the puller, unbolt the center bolt all the way and take the pulley
...remove pully from cranckshaft on a 1997 Nissan maxima? I am not familiar with a Nissan, but most pulleys are pressed on the crankshaft. You have to use a puller to get them off. AutoZone rents tools ...
Question about 1996 Cirrus
...remove crankshaft pulley without the timing gear coming too!! 2.5 litre using gear puller on pulley but it is bringing the timing gear with it. Tried driving the roller pin through but it wont move. ...
Question about 1996 Cirrus
...remove my front seal ( crankshaft) possibly without any fancy tools? Pulling and replacing a main seal on a crank cannot be done without "fancy" tools. If you go to www.autozone.com and make a free ...
...remove the crankshaft pulley to replace the gasket to stop leaking oil...how do i do this? Here's a guess, I've only done a few. Removing the pulley to change the seal would probably require removing ...
...gun works best to remove the bolt securing the balancer to the crankshaft. Some but not all models will need a puller to remove the balancer. Without stating model etc,I can offer no more ...
Question about 1996 LeSabre
...crankshaft pos. Sensor. Now I've used a pulley remover and it won't pop off. Any suggestions to remove it without destroying it? Are you using a gear puller or an actual harmonic bal. puller? You can ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions