Questions & Answers for: release ac pressure

...pressure release valve on the A.C unit in a 1994 mazda navajo? Yes. There is one on the back of the compressor. It will release the freon into the air when the pressure on the high side reaches about ...

Ad

...ac triple pressure switch have a valve to stop freon from releasing when you change it? No... it's just a pressure sensor switch. If the pressure is normal range, it maintains that connection... ...

Ad

Question about 2001 Santa Fe

1 Answer

...ac still blows cold. I topped it off and again it did it full pressure release for about 3-4 seconds. There is a high pressure relief valve on the compressor to avoid over filling the system and ...

Question about 2001 Santa Fe

1 Answer

...ac high pressure line and my husband wants to replace it himself. how does he remove the line? Such job I would recommend to have it done by an AC shop, the AC system will have to be recharged after ...

...ac blows warm. Tried a recharge kit and shows pressure in red(high). Released pressure. Worked great for 2 days and now it's doing the same thing. Pressure in red blowing warm May be a plugged drier ...

...release valve, then a water leak out the attached vent pipe is an indication that the valve is failing. To change the valve, the water must be allowed to cool (turn off AC power or gas) and the water ...

Question about 2007 Civic 1.8

2 Answers

...connector. That is the low side (low pressure) connector on the pipe that is the input to the AC compressor. Make sure you put the AC on maximum air and shake the Freon can as you release the

AC line burst or compressor safety release drained system (less likely). Sometimes a AC system is overcharged. There are 2 safety relays to protect the system and one is for low pressure and the other

...ac compressor relay. getting very high readings on the low pressure side. Need to start clutch in order release pressure and be able to add coolant If you make a jumper wire, you can bypass the low ...

...yourself AC recharge kit.Shake the canister briefly and release the refrigerant into the system until the recommended pressure has been achieved. Note: See next section for recommended pressure ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...