Questions & Answers for: rear speed sensor 2003 buick

where is crank sensor located on 1993 Buick LaSabre located? Under hood, passenger side, lower engine area, rear of crankshaft pulley, mounted in timing cover

...rear door panel 2003 Buick LaSabre How do you remove the right rear door panel on a 2003 Buick LaSabre You'll need to remove screws that are by the door handle, arm rest, under door and side of door ...

buick lasabre has rear disc or drum brakes? need to fix brakes but do not know if the 2004 buick lasabre has disc or drum brakes in rear section? it has disc brakes front and rear. just look. Disk all

...Buick LaSabre hesitates at speeds of 50-70 mph. Almost like the car is not getting the correct fuel or is about to stall Clean the sensor wire in the mass air flow sensor. Remove the tamper proof ...

...sensor if either one has to be replaced they are built in to the fuel pump.You can get to the fuel pump by removing the rear seat and removing the panel to remove the pump.The fuel pump is located in ...

...2003 buick lasabre is warped heat and cold and is pulled away from the vent that air from defroster comes out.I have been told I will have to buy a new one but they are 700.00 are there any where I ...

...rear seat does 2003 buick lesabre have an access panel in the center of the rear seat that opens to the trunk so skis can fit through. the park avenue has it In the trunk of the car there is a black ...

...rear speed sensor wires on 2003 buick rendezvous ABS code for rt rear speed sensor Remove the rear right wss and measure the resistance BTW the terminal of the connector 2-1,its should be BTW 0.6-2.5 ...

...not engage when the button is pressed? cruise control light on steering wheel comes on when pressed but nothing else - no light on dash etc. Is this a switch issue? Could be a speed sensor

...2003 Buick Lasabre with 120K onit. At 55-70 MPH. New tires on it. New bearing/hub at 95K miles.New ball joint and control arm. New tires, Rotated and Rebalanced. All when you rotate the tires and ...