Questions & Answers for: putting belt saturn 2000

Saturn won't start Hello .. I have a 2000 LS that won't start. I drove it to work, then home. While driving home, I put the A/C on, and the car seemed to be getting hot (needle almost to the middle). ...

saturn LS1 2.2 motor. The battery light went on and then after it was running for awhile it shut off. I took the alternator in and it was bad. I bought a new one and put it in the car. Battery is good

...putting it the Belt back on... Look at the alignment of the Pulleys. Most times the Tensioner or Idle Pulley are "canted" - meaning pitched or leaning forward, which causes the belt to "run off" the ...

...Saturn sc1 auto trans with 103000 mi. Has always run like a top, however today it started and ran as usual for the first couple of miles then when starting from a stop sign it accelerated very slowly ...

2000 Saturn SR2 - My son was driving it and it stopped (not a real good story from my son on whether the car stopped running or the trainy failed) Any ways, engine will not turn over. It is not ...

...belt on a 2000 saturn ls ls or sl two different models. 3.0 v6 has a belt kind of tricky take it to a shop. the chain on the sl or ls 4cyl 2.2 or 2.4 is also kinda tricky. the motor will be junk if ...

...belt Saturn makes, routing around the air conditioning unit entirely? the best way to determine the cause of the noise is to remove the drive belt and start the engine for a few minutes. if it is in ...

...2000 sl2 Here is that info.Have a full set of Torx sockets inaddition to the normal ones. Support the engine. Remove the air filter box.Remove the front engine mount. Pick an order here for the belt ...

...to take off the motor mount to put replace belt on a 2000 saturn v6 3.0 liter suspention belt Just put a spanner on the tensioner pulley (usually the smallest one) to turn it enough to get the belt ...

...belt on 2000 Saturn LW2. im not a mechanic so I prob put the timing belt on wrong. would that be a timing prob or a bent valves prob You probably have the cylinders 180°out of sync with the valves, ...