Questions & Answers for: problems crank angle sensor 2003

where are the jacking points on the hyundi accent where are the front and rear jacking points on the hyundi accent 1.5 mvi http://econtent.autozone.com:24991/znetrgs/repair_guide_content/en_us/images/

...hyundi accent judders and nealry stalls when turned on when i turn it on it judders and jerks and sometimes nearly stalls itself. After 10 seconds it revs itself automaticaly and its fine. What might ...

...will stall when driving and start back up later dear friend-i get the idea that your crank angle sensor is faulty ,best thing to do is take your vehicle for a diagnotic test befor changing

...accent, no spark at spark plugs. took out each plug and tried start with plug out it is not getting spark dear friend-my feeling is that we have a faulty crank angle sensor,have it tested or ...

...as it warmed up it would loose spark dear friend-it highly unlikely that both coil packs will be faulty,so the most probible cause will be the crank angle sensor,if no saticfaction it can be the

2003 hyundai accent crank but no start, nospark ,nofuel pump op. cranks but no start have it scan to check camshaft sensor and crankshaft sensor.and pcm.all 3 can cause no spark and no fuel problems.

...hot and will not start till it cools down. You need to replace the crank angle sensor. It only plays up when the engine is hot. If your stuck, pour water over it to cool it down and then try

...crank angle sensor and spark plugs changed Its driving me mad Have had this before where it will cut out and then sometimes it will not pick up and it was the mass air flow sensor just by airfilter ...

...Crank Angle sensor PO355 Circuit A. What does circuit A mean?? No spark , no injector pulse. Have already replaced sensor. Has power to injector and coil but don't pulse, fuel pump runs try ...

...in cluster not on, The problem aria in these models were IGNITOIN COIL PACK ,CRANK SENSOR and make sure that ENGINE TIMMING BELT has not broken. BE advised that a diagnostic check will be required