Questions & Answers for: pool pump motor covers

rule 1800 pool cover pump trips breaker the pump was working fine now today it trips the breaker It sounds like the pump motor has shorted. Probably time to invest in another one.

how do i tear down impellar housing on ao smith 2hp bn50 pool motor? take the impeller housing cover off. the shaft is threaded onto the impeller. Host the shaft and unthread the impeller.David

...motor Motor went bad on my Hayward pool pump... bought a new motor, so how do you get the pump off the motor? Remove the back cover from the motor, lock the shaft in place, thread off the

pool pump motor replacement, how do you remove the motor? has a threaded shaft. does the cover plate have to come off the pump/volute? No there is a cover on the other side of the motor thet comes off

...pool pump is 2 months old. It is a Hayward 1hp My pool pump is 2 months old. It is a Hayward 1hp pump for a above ground pool. It stopped running and was hot to the touch. I allowed it to cool down ...

...something wrong or if there is a problem with the pump. check that pool cover is not blocking filter intake.intake hose may need to be temporarily re-routed to a point below skimmer to drain

pool cover pump in the the gfi outlet trips The pump motor is likely grounded causing the GFI to trip. Once the seal inside a submersible pump fails, water enters the unit and the motor will fail. The

...pool pump impellor Removing pool pump impellor from motor shaft Separate pump and motor. Remove diffuser. Remove back cover from motor. Motor shaft has either a slot for a screwdriver or a flat area ...

pool pump reset switch where is it?? If there is a reset it will be locater near the power inputs, could be beneath a cover. Try looking here:http://www.hayward-pool.com/pdf/manuals/NorthStar.pdf

take apart rule pool cover pump pump just hums will not pump water motor seized how over the winter the discharge hoses freezes thus no discharge pump burns out motor that is