Questions & Answers for: picture of the distributor

need picture to install distributor i can't find a good picture that shows the proper way to line up distributor the distributor is fixed in 1 position it can only go in two ways if it is sloted

...distributor body, here is a picture, u should also change the Stator inside the distributor, this requires you remove the distributor from the engine and then drive out the roll pin that holds the ...

...distributor in is to carefully mark and picture the one you have and remove it. To do it this way !- remove the distributor cap and set it aside. 2- mark on the ENGINE with a SHARP FLAT BLADED screw ...

can't find it on my 96 blazer, need a picture of where it is the sensor is inside the distributor at the rear of the engine under the distributor cap, see picture below

...to reference how the position of the Distributor Cap and Distributor needs to be mounted with Pictures i can tell you what to do but i dont have access to pictures ,this is from my memory of ...

...picture of the cylinder order and the distributor. Number 1 cylinder is at the "white" location on the distributor. Good luck. Regards, netvan Ford straight 6 cylinder 1 - 5 - 3 - 6 - 2 - 4 The ...

...distributor connector and see if a picture shows the wire colors, and plug them back in matching the picture, or check ebay/amazon for a new one. Could be called Distributor connector, distributor ...

...distributor cap is on front side of engine? If the picture I looked at in manual is correct, the two large holes in cap goes toward the bottom. The coil tower is toward the top. Of the course the ...

picture like how to change the distributor cap on an 1995 chevrolet s10 pick up truck it is a 2.2 engine 5 speed truck i would appreciate any help thanks Are you looking to change just the cap, or the

distributor it is mounted remotely. See picture of the ICM below, are you wanting to replace the ICM or the distributor pickup (AKA crankshaft position sensor) which is located inside the distributor?