Questions & Answers for: pentair superflo pump starting

pump is not pulling the water from the pool just took off the pool cover. started the filter, but the pump is not pulling the water from the pool. *Check all of the drain plugs*...You would want to ...

...SuperFlo 1 1/2 HP 115V pump The GFI breaker trips as soon as I try to turn it on. pumps should not be connected to GFCI circuits they do pull a lot of juice at start time and this causes your GFCI to ...

...Pentair pump. The last couple of mornings there is a terrrible whine occurring as the pump kicks on. Perhaps it's cavitating, perhaps the bearings have worn out I don't know. The information plate on ...

Pool pump does not start Well, this could be caused by several different problems. The first step would be to make sure the breakers are not in a half-trip condition in the breaker panel. You should ...

...pentair superflo 3/4 HP, #340037,230v. After priming the pump, we started it and it seems to be running at half speed and making a continual rrrr rrrr rrrr sound. Checked the voltage, it is at 230v, ...

...Pentair Superflo 1 HP motor for my pool filter system. Hooked it up, primed it well and when you turn it on it runs, but after a couple minutes it starts smoking. Wiring is 110 which has new heavier ...

superflo. I wired it in and turned on the power, it hummed for a few secounds and trip the breaker. now it it wont work and just immediatly trips the breaker. Any ideas as this is motor is replacing a

PENTAIR SUPERFLO 1 1/2 HP SWIMMING POOL PUMP 340039 overheating and shuts off worked for a year shut down the pool and 6 mths later we started pool pump seemed fine but shuts it self off over heating ...

...Pentair Superflo 2 speed pool pump. Upon backwashing filter, restarted pump on low. It ran a few seconds then stopped. Switching to high runs fine. Any idea? could be the bearings are going bad, this ...

...pentair-superflo-vs-err-0021-plus-water.164075/ Try this. Hold down the 1 button and the plus and minus button at the same time for about 5 seconds. You should see all the lights light up and the ...