Questions & Answers for: nissan trail engine knock sensor

...engine ping at all times (causing the ECU to think that the knock sensor is bad because it's reporting ping at all times) - but also had codes for one or more O2 sensors. Nissan Scope Technician- 10 ...

nissan frontier 6cyl 3.3, not turbo charged. Knock sensors can be difficult to locate because there usually buried under intake or exhaust manifolds and misc. engine wiring and plumbing. Knock sensors

...Nissan Xterra on where the knock sensor is located? V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 ...

need the wiring diagram for a 2003 nissan x-trail engine? crank sensor unit what is A color of wire in nissan x trail cam position sensor 2003 model Maybe you need the full manual from here.

...sensor circuit short to ground- Knock sensor circuit short to power- Knock sensor circuit open- Faulty Engine Control Module (ECM) Read more: ...

...Nissan V6 is a bad idea, as the knock sensor helps prevent knock, which will over time hurt the engine. Knock sensors listen to the sound the cylindersw make during combustion. They are necessary for ...

Engine knock sounds like top end,been stripped nothing found Engine knock suddenly appeared whilst driving no smoke no loss of power plenty of fluids If you can open the bottom end check the piston ...

...sensor is. found this helpful answer from nissan mechanic on JustAnswer com Here's another that shows the sensor in the engine. Repair Guides Component Locations 3 5l vq35de V6 Engine AutoZone ...

...Nissan/Datsun Truck Pathfinder 2WD 3.0L MFI SOHC 6cyl The Knock Sensoris located: Under hood, center, rear engine area, below intake manifold, mounted in engine block.Must remove the intake to get ...

...Nissan X-Trail with a 3.0-liter engine, the crankshaft position sensor is typically located on the engine block. However, it's important to note that the 1995 X-Trail model was not available with a ...