...the relay located??? this problem is the multifunction switch in the steering column .there are two different circuits that travel through the multifunction turn signal switch this should be
...multifunction switch. Fig. Remove the multifunction switch (2) from the steering column Remove the multifunction switch from the steering column. Disconnect the electrical connectors from the ...
...MULTIFUNCTION SWITCH WITH TURN SIGNAL SWITCH, LIGHT SWITCH, WIPER SWITCH HAS TO BE REPLACED.YOU HAVE TO TURN OFF RADIO FIRST THEN REMOVE NEGATIVE BATTERY CABLE.THEN WAIT 20 MINUTES UNTIL AIRBAG IN ...
...multifunction switch is the fault. The flasher on this vehicle is part of the hazzard switch. It recieves power for turn flashing from the turn signal switch. It is very common for the turnsignal ...
Question about 2005 TrailBlazer
...multifunction switch retaining screw with the Philips screwdriver. The screw is located in the body of the switch, holding it to the steering column. Disconnect the wiring harness from the ...
Question about 2007 Navigator Ultimate 4x4
...multifunction switch position by sending multiple voltage reference signals to the multifunction switch. When the multifunction switch is in the LH or RH TURN positions, or the hazard lamp switch is ...
Question about 2007 Navigator Ultimate 4x4
...controls turn signals and flasher system. In the steering column. The lever you move to activate your turn signals, high/low beam headlights, wipers and washers is part of the multifunction
Question about 2005 Escape
...multifunction switch from the SJB fuse 25 (20A) when the ignition switch is in the ON or ACC position. The multifunction switch supplies power to the windshield wiper motor for the HIGH or ...
Question about 2005 Escape
...multifunction switch position by sending multiple voltage reference signals to the multifunction switch. When the multifunction switch is in the LH or RH TURN position, or the hazard lamp switch is ...
Question about 2005 Escape
...multifunction switch and the hazard switch are hard-wired to the SJB. When the multifunction switch is in the left or right turn position, or the hazard switch is engaged, the SJB processes this ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions