...degrees. just repace it and you may be in luck. the thermister acts as an overload fuse when the motor get bogged down and overheats instead of the motor blowing the thermister blows to protect
hobart A-200DT mixer lugs out lugs out in 2nd & 3rd gear with little effort motor overheats Can you be more specific?Does 1st gear run? are you overloading it?
motor and find the heat protection fuse on the side of the windings. The fuse is rated at 140 and has a red tip. You might be able to get one from Radio Shack but Viking sells them for $3. Solder into
...motor will draw excessive current and overheat. Where is the mixer hottest? The front at the gearbox/transmission or the rear where the motor is located? Maybe the transmission is lacking lubracation ...
Question about Artisan Series Tilt-Head Stand Mixer
overheat after grating cheese, make an awful noise to top it up , have i burned the gears ? You are putting too much pressure and overloading (motor) the Mixer. Specially if you run it for long time. ...
Question about Kitchen Aid KP26M1X 6 Quart Professional 600 Series Mixer
...overheat and stop working. Won't turn on. Smoke came up after it stopped, not a lot, but enough that I'm pretty sure the motor is burned up. bread is very tuff on mixers. always buy ...
Question about M-802 80qt Dough Bread Bakery Mixer 80quart
...from overheating. There may be a thermal cutout on the start winding that may need to be replaced if it did overheat. If the start winding burned then the motor would require rewinding or
...not restart, even after it was completely cooled down (next day). Any ideas? Did I burn out the motor? This was received as a gift in 2008 and only used about a dozen times. There is a good
motor doesn't run. Hi. I've got the thing apart and there is no power getting to the brushes. I've also checked the overheat sensor on the filed coils but it hasn't gone open circuit so that's not the
...motor may overheat and shut off as a safety precaution. In this case, you should allow the mixer to cool down for a while before using it again. Faulty wiring: If the mixer is shutting off when you ...
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions