Question about Air Tools & Compressors
...compressor around the country for about 14 years. thanks for the help. I can change the wiring and the plug my self if possible but another site seemed to talk in generalities and said that it would ...
Question about WL6502 5-Hp 20-gallon Oiless Air Compressor
...start when the air line is disconnected, but drags and the thermal overloads trip out the motor when the line is connected. I replaced the check valve already. did ya check the capacitor on the
...compressor. could it be problem or is it my motor? try blowing out motor i have used a armature cleaner like acetone while motor is unplugged or just replace brushes I have a 6.5 hp two stage coleman ...
Question about Powermate 60 Gallon Air Compressor
Compressor motor drags (Slow to get going under a load)The more pressure in tank,the worse it sounds. SOUNDS LIKE THE REG IS BAD
...compressor is trying to turn on and off causing the motor to drag and a very loud noise. Is this a simple repair? Someone said to get another air conditioner belt but smaller. Is this possible? Not ...
...motor drags down to a lowly putt putt and then picks up again. My shop lights down dim or anything. Also when it is building up pressure and nearing the cut out pressure which is 120lbs it will slow ...
...compressor) is excessive, or the motor is not coming up to full speed. If the motor has a 'run' capacitor (low uF value), it may be in trouble. Most compressor motors use a start capacitor (high uF), ...
...Motor will start and run without the drag of the compressor, but when belt is tightened at start up, it just turns very slowly and won't kick up. Don't know where to go from here. ,then either the ...
compressor and run the motor by itself...check the compressor to make sure it is not dragging the motor too much making the amps go up and tripping the breaker.. If the motor runs with the belt off of
Question about Extreme Contractor Series Air Compressor
...compressor comes on for a few seconds, makes a slight humming sound, then quits altogether; any suggestions? The only thing I can think of is that something is DRAGGING or binding, which "overloads" ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions