Questions & Answers for: microwave looks metal inside showing

...microwave will not heat what part is out? First...what do you hear? Is there any activity at all? If not and the light doesn't work and there is no panel indication...the problem is the inbound ...

...microwave after each use and this will prolong the life. Please dont use it you could do serious harm trust me i know Hi there! Paint comes off when too much moisture is present in the cavity. It ...

...metal is showing at the inside roof of the microwave. When i turned the microwave on there was sparks , as i looked inside a little metal is showing at the roof of the inside of the microwave can it ...

...metal caps on the low range (often 200 Ohms). If the display does not change, the fuse is blown; if it shows something in tenths or at least below 10 Ohms, it's OK. If you care to delve further into ...

...metal bowl in the microwave. There is noticable damage to the inside of the door. More specifically the inside of the door has burn mark and small section (maybe 1/8'') is actually burned out. The ...

...inside light, turntable, and internal cooling fan all come on when you try to microwave, with the symptoms you have, I would most strongly suspect a shorted high voltage rectifier diode or a bad ...

...microwave burnt out due to metal inside while cooking and hoping that only a fuse burned out. It may be the fuse or the thermal cutout / thermostat associated with the magnetron. You say you have the ...

...microwave just at the very bottom of the keypad. I'm guessing that you've already looked in the back of yours for a metal plate or sticker that lists your model number on it. Sometimes this ...

...microwave with paint that is designed for microwaves in general. Though, if you do this, you will have to let the paint dry up for at least 24 hours. I hope this helps you! High temp paint is NOT the ...

Microwave R-9H84B Pulled unit covers fuse checked ok. Inside cabinet 110a/c power line has two micro-switches in-line, they are open no power to machine, found metal plate on inside end when pressed &