...check your wiring harness for damage/corrosion/loose connections at the terminals. use a multimeter to check for voltage drops at various points. by what you have described it is probably a bad ...
...cable multiple times may have fixed it.) In case it helps, from the manual for models: MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737 WD-65837 / WD-73837 / WD-82837 ...
...loose, corroded, damaged, missing, or otherwise not making good contact with the engine or chassis. If you can't locate it, then ground has been using the "pigtail" wire coming off the negative ...
you unhook the jumper Several Things Check For Loose Ground Cable (other end not battery end. There Is Also A Junction Involved (ground) Where Engine And Body Grounds Come Together--LOOK AT THAT FIRST
...cable ends become loose due to corrosion and wear thin. Also try replacing the Mass Air Flow Sensor, it's the switch looking thing, to the right of the air filter box; I think it runs about $6-$10s. ...
...doesnt it will need to be cleared with a scanner-warning your factory radio will loose the function code when you remove the battery cable,make sure you have the code otherwise your radio will not ...
lrratic idal, loose of power, no check enging light on Needs a tune up...spark plug cables/ spark plugs
...cable to another, causing timing issues and misfire problems. That problem is aggravated by moisture and humidity. Look for old or loose plug wires loose plugs, etc.Look for ways to dsplace water in ...
...cable loose for 15 min and then let idle for 15 min.light stayed off until I drove it .ck eng light comes on and stays on.what next? 1990 ford pick up 302 engine efi I would check vacum lines or ...
...loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Bank angle sensor tripped and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions