Questions & Answers for: kreepy krawley tangling

Kreepy Krawley is not working I disconnect the hose & I can see it move the fins but then when I reconnect it does not move. There is enough pressure as the filter was just cleaned There are a few

Krawley and I am looking for what I believe was called a torpedo. It attaches to the KK and is battery powered to engage and pull the KK if it sits idle in one spot for a pre determined amount of time

Hi my kreepy krauly wont stay flat on the bottom of the pool??? Do you have any hose weights fitted to the kreepy hose? If you do,take it off and see if it makes a difference.Is this happening while ...

...Kreepy Krauly or separate the first two weights away from each other. 1. Throw your KK into the deep end of your pool and see at what angle the hose lies.2. If the hose is closer to parallel with the ...

kreepy krauly not cleaning whole pool the pool stays dirty as the kreepy does not clean all over If the pool hose has been used for a long time it becomes set in a particular position. Twist the hose ...

Kreepy kraully not cleaning complete pool If the pool hose has been connected to the Kreepy Krauly in the one position for a long time, the pool hose gets set is a position so the kreepy Krauly ...

...kreepy krawley The hose has broken at the end where the hose fits into the Kreepy Krauly. I need to remove the existing part that fits into the kreepy to re-attach it but can't seem to ...

my kreepy krauly wont clean the deep end of the swimming pool. Your situation is unusual in that most of the time these will stay in the deep end and not get to the shallow end. Make sure that your ...

my Kreepy Krawley Bull Shark won't sit flat on pool floor Try adjusting the hose weights 1m and 2m seems to work for most

my kreepy krawley conquest wont climb the walls check for low water flow from a blocked filter or cracked hose allowing air into the pump