Question about KDC-MP5032 CD Player
...Kenwood deck, "PROTECT" usually means that one of the speaker output wires is shorted. The first thing to do is pull the deck and inspect the wiring at the back, making sure there aren't any pinched ...
...flashing "PROTECT" I can hit standby and it goes off. If I hit standby again, PROTECT This is often caused by a problem with the speakers or speaker wiring. A speaker wire that's pinched behind the ...
...Kenwood in dash stereo keeps flashing "PROTECT" across the face plate. The unit was on and it just switched over to this flashing message. I have removed the face plate numerous times. i have not ...
my kenwood flash protect after i reset it sounds like it could be either a bad speaker, a shorted speaker wire, or a bad output ic inside the deck. kenwood kdc-w4034y flahs "protect"
Question about KDC-X492 Car CD/ MP3 Player
...kenwood kdc x492 in feb 09-put it in a car, have since sold that car and took the deck out, I now am trying to install the cd player in another car i own and am met with "protect" flashing on the ...
Question about KDC-MP342U Car CD Player
a time and reset the radio but the protect still flashes check the speakers for shorts or grounds. if all checks out fine try disconnecting power to the deck for a few seconds and then reconnecting it
kenwood cd player is flashing protect ive tryed the wiring and it still dose it is there a code i need the output ic inside of the deck is probably bad. unless you are good a desoldering and soldering
Question about KDC-X493 Car CD/ MP3 Player
my Kenwood KDC-X493 deck is flashing "Protect" , my Kenwood KDC-X493 deck is flashing "Protect" , what should I do to clear this? You can unplug the unit for 10 minutes. This will clear this
...kenwood car receiver flashes the word protect and will not do anything else. what is wrong? check your speakers and speaker wires for shorts, grounds or bare spots. if they check out, you may have a ...
i wired up my kenwood kdc-mp336 stereo nd it keeps flashing on the head deck protect how do i get rid of that It is going in to protect mode(check that no wires are crossed or hooked up wrong)
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions