20 Most Recent JVC AM FM CD DET FACE CAR STEREO Questions & Answers

Didn't the deck come with the mounting kit and instructions? Usually they even give to a cut-out template. Please contact JVC and ask for the installation paperwork. You might consider taking it and your car to a stereo installation shop to have it professionally installed.

JVC AM FM CD DET... | Answered on Mar 03, 2019

You're stuck in DEMO mode. When you see stereo's on display at a store it is set to a DEMO mode that cycles through colors, functions, etc so that potential customers can see the different aspects of the unit. To get it to stop changing colors you'll have to go into the menu and turn DEMO OFF.

JVC AM FM CD DET... | Answered on Feb 19, 2019

Did you ever find a fix for this? This is happening to me as well...thanks!

JVC AM FM CD DET... | Answered on Jan 18, 2019

Try this, tune to the desired radio station and holdpress the station number ( 1-6) for a while, it should blink twice to confirm its storage.

JVC AM FM CD DET... | Answered on Dec 12, 2018

here is the manual it would help to install your device


Ifthis solution helpful/useful for you please rate the solution. THANKS FOR USINGFIXYA.

JVC AM FM CD DET... | Answered on Oct 06, 2018

Make sure the red wire is still connected or make sure the red wire hasn't been severed. Also, check the fuses located in the engine compartment. The red wire connects accessory terminal in the fuse block. Also check the fuses in the cabin. This fuse box is typically located on the driver's side, at knee level, next to the door panel, and underneath the dashboard. As a last resort, the unit can be taken to an authorized or factory service center.

JVC AM FM CD DET... | Answered on Jun 03, 2018

This answer is found on page 16 of manual. goto BT mode and Press and hold [MENU]. Select

JVC AM FM CD DET... | Answered on May 07, 2018

Try disconnecting your battery, reconnecting it, and resetting your stereo. If that doesn't work, the constant power (yellow wire) or ignition wire (red wire) may have come in contact with ground or isn't properly connected. Make sure everything is connected properly and try resetting your stereo. If it is still flashing "protect", the unit needs servicing Contact JVC Customer Care Center at: 800-252-5722.

JVC AM FM CD DET... | Answered on Mar 20, 2018

I suggest you ensure the ground is made to a sensible ground point and the supplies are also good and the antenna is also properly grounded and then monitor the supply voltage and the current consumed by the radio until it begins to distort. If the voltage and current remain steady the fault is either local interference or inside the radio, probably in the tuner.

If the current climbs and the voltage remains steady the fault is likely in the audio section...

JVC AM FM CD DET... | Answered on Nov 18, 2017

Steroids are well known for providing one with the number of benefits for the overall health of the body. Steroids can be taken for various needs like - a person takes it for building muscles, while the other takes it for losing weight. And there are a lot more needs for which a person takes steroids to get more benefits for the overall health of the body. You can get the best options of steroids from a website that is well known for dealing with the variety of steroids that are made especially for you to get maximum benefits for the overall health. Also, one should keep in mind that along with the benefits there are also some of the side effects that one has to face from taking steroids. And you can get more information on steroids and get steroids from one of the website that deals with the best products from Buy Steroids

JVC AM FM CD DET... | Answered on Sep 15, 2017

Setting the clock
  • Press and hold SEL (select) for more than 2 seconds. "DEMO", "CLOCK H", "CLOCK M", "DIMMER", or "AMP GAIN" appears on the display.
  • Set the hour.
  • 1. Select "CLOCK H" (hour) if not shown on the display.
  • 2. Adjust the hour.Using the Control Knob.rwalker540_3.jpg
  • Set the minute.
  • 1. Select "CLOCK M" (minute).
  • 2. Adjust the minute. Using the Control Knob
  • rwalker540_4.jpg
  • Finish the setting. To check the current clock time or change the display mode.
  • Press DISP (display) repeatedly. Each time you press the button, the display changes as follows:
  • • During tuner operation:
  • • During CD operation:
  • • During power off:
  • The power turns on and the clock time is shown for 5 seconds, then the power turns off.

JVC AM FM CD DET... | Answered on Aug 30, 2017

Contact JVC customer service please.

JVC AM FM CD DET... | Answered on Jun 27, 2017

Follow the instructions in the first column of the first page of the manual.

JVC AM FM CD DET... | Answered on Apr 24, 2017

Did you verify it has 12 volts on it's main power wire? Make sure the ground connection is good?

JVC AM FM CD DET... | Answered on Jul 03, 2016

Not finding what you are looking for?

916 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top JVC Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5013 Answers


Level 3 Expert

84027 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a JVC Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

JVC Car Audio & Video

  • JVC Car Audio & Video

Most Popular Question

want know about steroids

  • Car Audio & Video