Questions & Answers for: karcher reset switch

Karcher K3.92 M 1750 PSI poweer Washer motor won't start. Followed Reset/Test/Reset sequence with cord plugged directly into outlet. Light on cord near Reset comes on when Reset pressed down but goes ...

...RESET'' on GFCI is pressed the motor turns on. This is regardless of the power switch being ''OFF'' or ''ON'' on the side of the unit OR regardless if the gun trigger is being pulled. When the power ...

...reset a karcher pressure washer the button pops up and wont go down aqnd is under the switch The Knob is broken off of the Plastic Shaft..to the switch assembly. A new switch assembly is available ...

Karcher electric power washer. The circuit breaker only works for less than one minute. I have to press the reset again and again. Please help. Thanks. do you mean the gfci that is normally at the end

...Karcher 3.86 electric pressure washer: With everything hooked up, water turned on, it makes a very loud humming noise until I pull the trigger on the wand and then it works normally. But when I ...

karcher problems The motor will not start when switched on Check to see if there is a red button on the motor. If there is it is likely an electrical reset button. Push it in and check to see if there

...karcher pressure washer wont start//? worked for awhile now wont turn on there seems to be no difference in the on and off switch the light comes on in the reset but nothing happens unit may have ...

Karcher 2 motor won’t come on. It’s plugged in and switched on. It works fine the other day. Did you try to reset the Ground Fault interrupter located at the end of the cord that plugs into the power ...

...the front of the house and now it isnt working. i have changed the fuse and different socket but nothing?? any ideas? My Karcher has a reset button as part of the cord. If yours is the same, try ...

...karcher K7 seems to keep blowing the fuse in my extension cable..any ideas ?? The following methods, according to Check Appliance, may help you address the problem: Check that the cable is inserted ...