Questions & Answers for: jaguar type gearbox fault warning

Question about 2004 X-Type

2 Answers

...Jaguar S Type Hi, Jaguar S Type, March 2000, 94000 miles, started showing warning sign "gearbox fault" intermittently. No noise and running smooth but somtimes erratic gear changes. Jaguar dealer ...

Ad

Question about 2000 S-Type

9 Answers

...Jaguar S Type Hi, Jaguar S Type, March 2000, 94000 miles, started showing warning sign "gearbox fault" intermittently. No noise and running smooth but somtimes erratic gear changes. Jaguar dealer ...

Ad

...gearbox fault message, what does I am getting a the following message "gearbox fault" u need to have the electronic control module tested, there will be a trouble code to expalin what part is causing ...

...jaguar 2001 s-type cuts off when I sit at a stop light. If the car starts again without trouble - it is probably an air leak on the inlet manifold or associated pipework. If the car is very 'lumpy'' ...

...Jaguar X type there are no warning lights on. When I start driving the gearbox fault light pops on and the car will not accelerate past 15-20mph. The last diagnostic check I had told me that I needed ...

...on what is going on. Just because it states - gearbox fault - it will not always actually be a true g/box fault (as I have found out in the past with these cars) Hope this helps - good

...gearbox fault call the queen check gearbox fluids This may not be a gearbox fault. I have had the experience of an engine misfire/faulty coil which causes a change in engine load which ...

Jaguar s type 03 gearbox fault warning light on dashboard, gear stuck in 4, reverse engages ok, what could it be? gearbox fault light on, gear stuck in 4th sounds like it is in get you home because of

Question about 2008 X-Type 2.2

1 Answer

...gearbox warning light staying on you need to use a fault code reader to get fault codes from the transmission control module or take to dealer.with the correct diagnostic equipment. could be lots of ...

...jaguar x type 2002, some times, the engine does not rev after starting and goes off on it's own. you need to get the fault codes out of the tcm (transmission control module) to help sort that out but ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...