...fuse. I have also seen the convergence IC's go bad then the set dies because the main fuse blows out, the power supply will go bad because of a surge. If you have no TV repair knowledge, play it safe ...
Question about HCM4216W 42" Rear Projection Television
...fuse on the IC board is blown. To check the pico fuses you're merely testing for continuity. If you get an infinate reading you're in good shape - if it doesn't budge the meter the fuse is open... ...
IC's. The pico fuse supplying the left IC was blown however the right one wasn't and none of my resistors seemed to be blown. I replaced both STK392-040's and the pico fuse on the left. When I powered
TV convergence My colors, are of specifically the line-up and and angularity. The brief descriptions that are given are the same problems that I am faced with. I have removed the circuit board which ...
fuses on the boards, --- sometimes when the IC's go, they will take out a fuse to the convergence power supply. If you find any bad fuses, replace them accordingly! Hope that helps u alot... thank u!!
Question about LN-T4665F 46 in. LCD Television
...fuse will have the number 3150 on it. You will need to use an ohm meter to test these fuses The stk ic's are on the "D" board, attached to large heat sinks, When looking from the back you can see the ...
Question about HC-P4752W 47" Rear Projection HDTV-Ready Television
Bought a convergence repair kit for my Samsung HCP-4752W DLP...ICs are replaced and I'm ready to refit the board back in the unit...the kit came with two 3 amp pico fuses...I can not see any similar ...
...FUSE GONE EVERY TIME. I CHANGE STR & SUPPLY IC. connect a series lamp for sefty to the monitor. start to disconnect the component from fuse ,line filter, bridge rectifier, filter capacitor, check ...
Question about HC-P4752W 47" Rear Projection HDTV-Ready Television
I have a Samsung Rear Projection TV with an HDTV 1080i Monitor. I know the convergence is messed up because the blue would not move when I tried to adjust it on the menu. So, then I tried to make it ...
does not display when plugged into the CPU it indicates optimum 12 i think ur disply coming dull that problem in powerboard inverter ics 2nos can u replace that 2nos of ics and chek inverter fuse
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions