Questions & Answers for: governor pressure sensor for jeep grand cherokee

...Governor Pressure Above 3 PSI In Gear At 0 MPH Conditions: Engine started; vehicle driven to a speed over 30 mph, and the PCM detected the Governor Pressure Sensor was more than 3 psi with the ...

Ad

...governor pressure solenoid valve in the transmission. To test this code accurately, you would need to have Chrysler connect their scan tool to it. With that, they can check the whole system. The ...

Ad

Question about 2001 Grand Cherokee

1 Answer

...governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI ...

Question about 2000 Grand Cherokee

1 Answer

...governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of ...

Question about 2001 Grand Cherokee

1 Answer

Governor Pressure Sensor Offset Volts Too High/Low Conditions: Key on or engine running. Gear selector in Park or Neutral. PCM detected an out-of-range Governor Pressure Sensor signal for 1.3 seconds.

Question about 1997 Grand Cherokee

0 Answer

...pressure in the trans. I have a code P1756. Governor is responsible for internal trans failure. 1997 Grand cherokee limited quattro track. know what the problem is do not know where the governor is ...

Question about 1997 Grand Cherokee

2 Answers

...Governor pressure above 3psi in gear with MPH 0. Either an input or output speed sensor is malfunctioning or the governor, governors go a lot on those transmissions. P1757 = Governor Pressure Above 3 ...

Question about 2004 Grand Cherokee

1 Answer

...Governor Pressure Sensor Voltage Too High This code is refer for the governor pressure sensor which is located in the valve body of the transmission. If getting power to the sensor and the wires are ...

Question about 1999 Grand Cherokee

1 Answer

governor pressure sensor .and your pressure sensor .to fit them drop the pan in your gearbox .remove your filter chance to change that will it is off. now you can see both your parts.pull off the plug

...governor pressure sensor and transducer, internal trans wiring harness, external harness underhood, wiring harness for underhood fuse panel including the fuse panel, all the 02 sensors since they ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...