Questions & Answers for: generator cord stuck

...generator I have never used. When I pulled the cord it just got stuck. It's not recoiling at all. If you've got a receipt that shows it's less than 2 years old you might be able to get your local ...

Generator in March. Ran it twice and put it away. It's December. The snow is here. Oil level is good. Gas is good. everything looks brand new. Choke is in position. Gas switch is on. On/Off red switch

...run in most places. Most extension cords wont be able to hold that much power, so if your not using some sort of generator, make sure you dont try to use a 120v extension cord (like the orange

...stuck closed and the engin isn't getting air and is now flooded, Remove spark plug overnight to allow gas to evap. Spay the carb and lincage with WD 40 to clean everything up; check throttle ...

...cord and there is fuel/oil in the cylinder, it will fly out when you pull it. Stay out of the way. If that is not the problem ( I think it is though), double check the oil level. Check the color of ...

...cord. Checked the oil and there is gas in it? The rings are stuck to the cylinder wall. Remove spark plug and spray some pb blaster in the hole. 3 or 4 seconds worth. Let sit a day then try. If no go ...

generac 5500 generator shaft only turns 3/4 Cord was stuck. Removed the housing and the shaft only turns 3/4 left or right. Threw the rod. Replace the engine

...generator but the pull choke seems stuck it won't start The pull cord is like a starter on a car (separate from the motor/engine). If the pull cord will not turn it could be because ...

my kubota motor cord wont turn over when I pull the cord, it is stuck you need to undo the pull cord spring and check if the spring on the recoil is broken. replace

...itself I have to hold it for it to charge.. Help You need a new cord the end must be bent. Check and see that there is nothing like lent stuck in the end of the cord and that the cord end is not ...