Questions & Answers for: fix trunk latch

...fix this annoying problem, should I replace the Trunk Latch or the Latch Assembly part that's located on the inside of the trunk? At all costs, I want to avoid having to take my car to a local Honda ...

fix? With the trunk open try putting the key in and turning so that the latch swings open. This may be the problem. The latch may be stuck closed. with the key turned make sure the latch is open if it

...fix it. Open trunk, look down at the middle where the trunk lid connects with bottom latch. There is a small lever that you can move up or down. Pull it up. It must be in the up position to unlatch ...

...won't close - is there something I can do to fix this on my own? Tailgate/trunk latch will not engage so the tailgate just bounces won't close - is there something I can do to fix this on my

...fix this problem by tightening the bolts that hold the trunk latch. If that doesn't work, order and install a new latch. After fixing the latch, find a friend, and get into the trunk, and make ...

...trunk fixed, it won't latch? 96 were can I get my trunk fixed, it won't latch? 96 bonneville Any repair shop (body shop or auto repair shop) should be able to handle trunk repair. You may want to ...

... I can not open gas door and can not close trunk emergency release should be in the trunk as for the closing of the trunk, you need to disconnect the cable at the trunk latch until you can get it ...

...trunk is open. how do I fix it? Remove battery cable,wait 10 minutes and reinstall. If expert Perkins suggestion fails you may have damaged the switch in the trunk latch that signal the system the ...

...trunk with pull latch next to driver seat. No problem opening trunk using remote and key. Please help how can I fix pulled latch latch cable damaged or dislodged from clip [which is possibly broken

...fix the problem. Check the trunk seal: If the seal around the trunk is damaged or not properly seated, it may be allowing air to escape, which could cause the trunk to open. Try inspecting the seal ...