Questions & Answers for: error code module 1992 olds

...98 getting an error code #62..can you tell me what it is referring to? Code #62 in the Haynes repair manual refers to the transaxle gear switch signal circuits. Hope this answers your

...Olds models, I've tried the following to re-program the fobs, but with no luck: - Analyzed ALDL connector to look for wires in spaces A and G to jumper; 4 wires found, but none in space G - Dropped ...

...1992 Olds 98 Regency Elite won't close the trunk. I checked the fuse and it is good. If I remove the trunk lid closer motor and worm gear will the trunk close all the way or does the closer motor and ...

...olds wont start i can jump it across the selinoid and it starts but when i remove jumper wire it dies have you replaced the selinoid? It sounds like the 12 volts is not staying constant to the other ...

1992 olds. regency. need to know what the code of 31 and 34 means - check engine light is on - kills quite often wondering if it could be a maf sensor? if you have an Autozone near you they will put a

olds regency elite. The ignition I have a 92 olds regency elite. The engine runs rough when it gets warm and the ignition modual keeps going out. I have replaced it three times and seems to fix it for

...Olds Regency that, up until this morning, has given me no problems. I went to the store this morning and now the car won't start. When you turn the key you get absolutely nothing? Tried jumper cables ...

...module problem do the engine control system test for the poss stored trouble code, go to the link for that procedure. ...

...I'm trying to locate the a/c compressor relay in the relay and fuse center in a 1992 olds 98 regency elite. no diagram. under hood fuse box-check the label it is in there and will be

...1992 isuzu rodeo? 3.1 engine. on the cam. why not post a symptom then ask a question.?????? is this the single or twin cam, the later has 2 cam sensors. all cam sensors are sensors that measure cam ...