Questions & Answers for: ect sensor ford

...ECT) Sensor ? 4.6L and 5.4L Removal and Installation Remove the engine coolant temperature (ECT) sensor. Disconnect the electrical connector. Remove the ECT sensor. The ECT sensor: sends the PCM a ...

...ECT sensor and the sensor for How to identify the differences between ECT (engine coolant temperature) sensor and the sensor for the temperature panel and their location to one another (which one is ...

...ect sensor located Hi: The engine coolant temp sensor, or ECT is located close to where the upper radiator hose conncects to the engine. It is a hex shaped sensor, with a electrical connector coming ...

...ect sensor located on my 1999 Ford Explorer 4.0 v6 Most ECT sensors (arrow) can be found on the intake manifold, near the water outlet housing... Hope helps (remember to arte this). This is the worst ...

...ECT) sensor is a thermistor (a device which changes resistance or voltage as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM ...

...ect sensor on my 2002 ford ranger, 4.0 v6 4x4, and how do I replace it It's fuel injected. Getting p0117 code. Engine check light on. One is sensor the other sending, which is which and is it a push ...

...ECT) sensor --- circuit malfunction=== causes --- wiring-- ECT sensor bump the cat converter with the heel of your hand and if it rattles replace the cat converter if the cat converter is solid , ...

Where is the ECT sensor signal circuit in a Ford Windstar 1998 and it's wiring harness Your ECT system registers wheel spin from the wheel speed sensors.

...ect,came right back,wont start What year is it ? The thermostat needs to be replaced . P1116 FORD - Engine Coolant Temperature Sensor is Out of Self-Test Range Read more: ...

...ECT sensor maximum is 4.6 volts or -50°C (-46 °F). Note on some vehicles that are not equipped with an ECT sensor, CHT can be used and can set this DTC. Open circuit in harness Sensor signal short to ...