...weight on one side of the drum but even if the load is adjusted the machine will continue to bounce. We have confirmed that the machine is level and the lags are adjusted correctly. the drum was stif ...
...when that area reaches the bottom, the weight of the drum causes a clunk. a damaged belt that clunks when the tear hits the drum a collapsing drum roller(replace in pairs) each is easy to fix,
weight of the drum 'hangs' on the stabilizers. That might also be the problem with not spinning fast enough, although I think that its not spinning fast enough because there's too much water inside. I
...weight. Loose tub weights are rare on this model but they cause a loud knocking noise which is often worse when the washing machine is revving up to spin and dying down from a spin (suspension ...
Question about Neptune MAH5500B Front Load Washer
...drum isn't turning normally. It will spin fine until we put clothes in it. It will barely turn with the clothes - but when the weight of the clothes are removed - it turns properly. Wondering if we ...
Question about MAH8700A Front Load Washer
...that the weight of the drum swivles back & forth on.it is made of white plastic. Some times the floor is not stable, I was told to place a sheet of 3/4 inch plyboard under the washer to
Question about Neptune MAH5500B Front Load Washer
...This is at all times. This is not water that you hear. It is a form of liquid ballast that stabilizes the drum and counterbalances the weight of the clothes when the machine spins the clothes
mywasher is off balance during spin cycle Posssible shifting in the suspension of the drum or the failure of the shock absorbers. Look under the drum for the suspension, the counter weights and the ...
during spin cycle It is possible that the drive is tight on the washer spindle and so is making the drum to agitate. You must check the free movement of the motor and washer. Also the drum suspension
...of the washer with a tilt to the rear for easy drain. Also check for bearing fault if there is wobbling, check for counter weight or alignment fault of the drum if the frames are rusted.
Usually answered in minutes!
1,743 Questions
867 Questions
815 Questions
489 Questions
196 Questions