Questions & Answers for: drive cycle ford f150

...light will stay off for a drive cycle and still comes back on. The last reading before the seal was replaced was a "system 2 lean" reading...any ideas what to try next? Clean the mass air flow

...f150 4x4 4.6 tow package. Just started driving this truck. Driving down the highway on a 75-85 degree day w/ ~3500 lbs behind it on a trailer. The clutch is turning the fan on every half mile or so ...

Drive cycle : Operating temp engine ( let it warm up ) At least 1/2 tank fuel A run of normal throttle usage, to maintain at least 46 mph for 5 min, back down to a stop and then back over 46 mph again

...drive cycle what is the emissions reset drive cycle on a 1998 ford f150? You have to drive the vehicle after the codes have been reset to let the monitors do their tests....If every test ok it will ...

...Drive Cycle : http://www.obdii.com/drivecycleford.html If you just want to turn off the light, you can disconnect the battery for 10 min, and it will go out, but once you complete a drive cycle, if ...

...drive cycle miles to make ready emission test on ford f150 5.0 engine? a drive cycle is not measured in miles driven but in the type of driving done, here is a ford drive cycle procedure to clear the ...

...Drive cycle - how many miles ? I need to get an emissions test, and I recently disconnected the battery so the computer "was not ready" yesterday IT IS NOT A CERTAIN NUMBER OF MILES READ THE TEST ...

...come up again after resetting, it is 2 drive cycles. Until that time, the DTC P1000 is set ( tests not completed ). Here is the write up on Ford drive cycles ...

drive cycle instructions need to reset computer on my truck so I need to learn how to do the drive cycle for this truck Your owner manual should have your info.

...Ford F150 5.4L. There were no codes the only thing it said was I/M Yes. I accidently cleared that now it won't come back to I/M Yes. What do i do? Need help now. I have tried unhooking the battery, ...